Bosch WAK24260GB/17 motor.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch WAK24260GB/17 motor.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • September 24, 2016 at 5:11 am #89380
    aqualectric
    Participant

    Bosch WAK24260GB/17 washer. FD9509.

    Machine wouldn’t spin properly so unplugged the small sensor plug from the motor and tried again. Span perfectly and seems to work as normal through several washes. I’ve looked up the part (00637879) – called a 3G sensor. Googled that and got a BSH video from BSH Chile and reading between the lines (my Spanish is not brilliant) it’s seems to be a motor mounted out of balance sensor.
    Question is why does the machine work fine with it unplugged? Does it harm the machine if left unplugged? I can replace it…. just curious about its function and necessity.

    Any ideas?

    Thanks,

    Steve.

    September 24, 2016 at 7:46 am #441214
    electrofix
    Moderator

    Re: Bosch WAK24260GB/17 motor.

    would be interested to find its function, seems weird the machine it not setup to detect its not connected.
    not many people seem to have bosch info on here, one that springs to mind is NOMAD suggest you pm him and ask if he can help

    Dave

    September 24, 2016 at 7:51 pm #441215
    nomadPaul
    Participant

    Re: Bosch WAK24260GB/17 motor.

    The 3g sensor is what’s detecting out of balance loads. I wouldn’t trust running it without it unless you want the machine walking across the floor !

    September 25, 2016 at 8:16 pm #441216
    aqualectric
    Participant

    Re: Bosch WAK24260GB/17 motor.

    Thanks for the replies.
    I was interested to find out what it did as it didn’t throw a fault code. I guessed it might be an OOB sensor and even though I found the 3G sensor on BSH site I wasn’t sure exactly what it did.

    Thanks again!

    Steve.

    September 26, 2016 at 8:03 am #441217
    aqualectric
    Participant

    Re: Bosch WAK24260GB/17 motor.

    One more question….. do these sensors fail often and is there anything obvious that causes it?

    Steve.

    September 26, 2016 at 9:44 pm #441218
    nomadPaul
    Participant

    Re: Bosch WAK24260GB/17 motor.

    They don’t fail that often . There are occasions when the motor gets noisy (even from new) and that can cause problems with the 3D sensor (probably electrical noise interference) The ones that do fail tend to show up fairly early in their life .

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.