Bosch SGS45E02GB/45 wont start program

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Bosch SGS45E02GB/45 wont start program

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 30, 2016 at 3:07 pm #89720
    ChrisRatters
    Participant

    Hi Dishwasher initial fault would not drain cleared blockage , then would not fill replaced water inlet solenoid. When turned on program selected it drains then nothing does not start. I have filled with water it will drain if program cleared no water coming in via new water switch? I did have an issue with door switch which I had to reposition catch after checking pump with door open. Could this be the problem?

    November 1, 2016 at 10:32 am #442299
    ChrisRatters
    Participant

    Re: Bosch SGS45E02GB/45 wont start program

    Back again Mem Sahib fed up kitchen covered in bits! I have bridged door switch still nothing program wont start and no water flow in so that idea out?
    It will drain if I fill it with water via kettle etc and cancel program or move red lever on left hand side. Is there a way to check any thing else? Thanks Chris

    November 1, 2016 at 3:57 pm #442300
    Martin
    Participant

    Re: Bosch SGS45E02GB/45 wont start program

    Severe case if barking up the wrong tree before waiting for an answer first. 😉

    Most likely the Impellor Jug (00424099) needs replacing.

    November 3, 2016 at 4:06 pm #442301
    ChrisRatters
    Participant

    Re: Bosch SGS45E02GB/45 wont start program

    Job done working OK judicious removal and refitting of all connector blocks seems to have sorted it. Is there a fault code for impellor jug other comments on web advise if its defective the machine fills and drains repeatedly?
    Thanks for all those that looked and advice

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.