Ceramic hob cut out size

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Ceramic hob cut out size

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 2, 2016 at 2:39 pm #90021
    folleyball
    Participant

    Hi sorry if this is in the wrong section.

    I’m trying to find an electric ceramic hob that will fit a granite worktop with a width of 55cm. Most of them are 56. Whirlpool did one (AKM359NE), but it’s not available anywhere.
    The current one is a really old Diplomat.
    Many thanks

    December 12, 2016 at 8:55 am #443287
    AMS
    Participant

    Re: Ceramic hob cut out size

    Have a look at the hobs on ao.com. In the technical specs there is often the cut-out size required, often in the FAQ’s.

    December 13, 2016 at 5:11 pm #443288
    admin
    Keymaster

    Re: Ceramic hob cut out size

    Hi

    Or use a hand grinder with a cutting disc to grind off the extra couple of mm you require. use plenty of water else it’ll get very dusty.Ive done this without a problem as you would not be leaning on top but from within the present hole.

    Bryan

    December 16, 2016 at 10:42 am #443289
    trotter
    Participant

    Re: Ceramic hob cut out size

    http://www.montpellier-appliances.com/p … amic-hobs/

    This one should fit without the clips 😉

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.