Indesit IWDE126UK

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Indesit IWDE126UK

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • January 19, 2017 at 1:47 pm #90374
    rickard
    Participant

    This morning I went to look at this built in washer dryer, It will fill with water and wash fine but when it comes to pump out the pump will run and pump out for about 20 seconds, then it will stop and every light horizontal and vertical will flash, if you reset it on pump only it will do the same stop after 20 seconds. Could this be a control unit fault or just drain pump or something else throwing the board out. I did not have a pump to try in it and will have to order one to test it, any help please. Thanks. Andy

    January 19, 2017 at 3:17 pm #444579
    iadom
    Moderator

    Re: Indesit IWDE126UK

    Could be related to This fault, can’t say I’ve done one on the later type pcb’s though??

    January 19, 2017 at 4:39 pm #444580
    rickard
    Participant

    Re: Indesit IWDE126UK

    Thanks Jim
    I will give EMW a ring

    January 19, 2017 at 4:46 pm #444581
    johnnyj
    Participant

    Re: Indesit IWDE126UK

    I would try plugging another thermistor in place of the dryer thermistor first.

    January 19, 2017 at 5:14 pm #444582
    iadom
    Moderator

    Re: Indesit IWDE126UK

    DOH, keep forgetting it’s a washer dryer and just how many wierd faults the dryer ntc can throw up. 🙂

    January 25, 2017 at 5:29 pm #444583
    rickard
    Participant

    Re: Indesit IWDE126UK

    Thanks Guys, I tried a new sensor and still the same so got a board from EMW and fine all working I could not see any damage to the board as you suggested though.
    Thanks for your help

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.