Electrolux ESL6115 dishwasher fault

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Electrolux ESL6115 dishwasher fault

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 13, 2017 at 3:13 pm #90587
    Ben_B
    Participant

    Hello, I have an Electrolux 6115 dishwasher that has worked fine for 10 years until yesterday. When I switch on the door power button ready to set the programme it starts what sounds like the drain pump working – it gurgles as if it is trying to suck but there is no liquid to suck. Obviously it shouldn’t be doing anything at this stage as I haven’t selected a programme and closed the door.
    If I hold down the Cancel button as if to cancel a programme the gurgling stops after a few seconds. I can then select a programme but when I close the door to start it nothing happens. I’ve noticed that the End Programme LED is flashing 8 times if that is significant. Any help would be much appreciated as I like to fix rather than replace (and I’ve just spend £40 on a new lower spray arm and rollers for the bottom drawer!).
    Thanks in advance
    Ben

    February 14, 2017 at 4:15 am #445280
    captaincaveman1
    Participant

    Re: Electrolux ESL6115 dishwasher fault

    It has activated the anti flood device there will be water in its base. you will need to remove the water from the base and then run it checking for any leaks

    February 14, 2017 at 10:53 am #445281
    Ben_B
    Participant

    Re: Electrolux ESL6115 dishwasher fault

    Thanks very much for the quick response – I’ve taken the machine out so I can get to it and I’ll have a look for water in the base and leaks.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.