- This topic has 6 replies, 4 voices, and was last updated 9 years, 1 month ago by
.
-
Posts
-
DYN7164D1x/1-80
3100558813356483
Tried a new interlock on this 4 year old machine but no go
Lock light flashes 10x then goes out door not locked
What is likely solution?
Re: Hoover DYN7164 Door not locking
Had loads of hoovers with this problem, usually board gone. Did you solve it Neil ?
Re: Hoover DYN7164 Door not locking
No went right through everything,
Motor was good, heater a bit on the low side.Customer scrapped it after that but i was doing some research for next time..
would i need a pre programmed board and do you know of a good source?Re: Hoover DYN7164 Door not locking
To be honest i’ve never purchased a new one. The problems I had were when refurbishing machines so I used replacement pcb’s that I took off machines with bearings gone. Masterpart do stock them but it doesnt mention whether they are programmed or not
Re: Hoover DYN7164 Door not locking
Yes I agree sounds like the Main Control Board, to order one you will need the the serial number which is on the label on the inside of the door it will begin 3100********, this will give the variant and date of manufacture as there are different boards depending on date of manufacture. The control modules are around £50.00 less discount plus vat, so is a do able job. If you want, send me the serial number and I can give you definite prices. Regards Neil
- You must be logged in to reply to this topic.