beko wi1573

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › beko wi1573

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • May 2, 2017 at 4:31 pm #91170
    mikehha
    Participant

    good evening all
    We have here a beko wi1573 with no motor action also if you pause and cancel the program the door interlock wont release and the pump cuts in and out.until you turn it off at the mains.I know there has been a problem with the dc modules but would this affect the lock and program

    May 2, 2017 at 6:52 pm #447320
    electrofix
    Moderator

    Re: beko wi1573

    not sure if you have tech access so have pm’ed you some info

    dave

    May 3, 2017 at 12:46 pm #447321
    mikehha
    Participant

    Re: beko wi1573

    many thanks for the info dave will store it away for a rainy day.The information you sent seems to be for a 3phase motor mine is brushed. but it gave me the jist of the fault codes and where to look so again many thanks
    mike

    May 3, 2017 at 1:03 pm #447322
    electrofix
    Moderator

    Re: beko wi1573

    no probs m8 anytime
    yours must be on the change over to brushless so will prob be machines out there with same model with brushless motor.

    Dave

    May 3, 2017 at 6:45 pm #447323
    Seamy
    Participant

    Re: beko wi1573

    DC modules were prone to popping out the track of p.c.b if too much current was pulled by the motor. Have found excess brush dust sometimes shorted out to motor frame causing same problem.
    Check loom to pump for shorting against front frame , got this problem on a few of the basic Beko’s.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.