- This topic has 4 replies, 2 voices, and was last updated 8 years, 11 months ago by
.
-
Posts
-
The light in my Hygena AE6BMS oven is no longer working. I ordered a replacement from UK Whitegoods but the bulb is quite complex and the old one seems quite firmly fixed in place. How do I remove the old bulb (e.g. not sure whether it just needs to be pulled quite hard, or if I need to twist it, or do something else)?
Re: Hygena AE6BMS – Replacing light bulb
most of these lamps unscrew. picture is a bit small to see properly but most are a small screw thread
Dave
Re: Hygena AE6BMS – Replacing light bulb
Hi Dave, the picture did come out quite small! I’ve attached a larger one. It doesn’t screw in – there are connectors that stick up (or down) at the back as well as triangular fins that stick out (you can see one near the glass bit). Does this help?
Re: Hygena AE6BMS – Replacing light bulb
oh i see you are trying to replace the whole lamholder
take back off oven
disconnect wires
from the back, keep pressure on the old lampholder with one hand. with the otherhand using a small screwdriver push each of the barbs in (triangular fins) till it pops through the hole
when old unit is out the new lampholder should only go in one way. take careful not of which way the terminal face as if you get it wrong the cables may not reachDave
- You must be logged in to reply to this topic.