Miele WT2670 water in drum after dry cycle

Re: Miele WT2670 water in drum after dry cycle

have you cleaned the filter ?

when the machine dries it uses a small amount of cold water to condense the steam so if this water cant drain it will fill up

Dave

Re: Miele WT2670 water in drum after dry cycle

if it has not got a hole in it dont replace it

take it off and run a hose through it, if its not clear bend is aroung to loosen crap and rinse again
to be honest if your going to have a blockage it more likely in the sump hose
you dont use colour catchers do you ?

Dave

Re: Miele WT2670 water in drum after dry cycle

you have to take the front off the machine

door rubber clip off and unclip rubber
take kick strip off
remove screws from bottom of casing
remove screws from door lock
remove large single screw bottom of door

think that’s the lot, it should pull out a but at the bottom and drop. take care to remember where the emergency door release goes

after that you can now see under the machine to access the sump

Dave

Re: Miele WT2670 water in drum after dry cycle

i would not have expected that. i would expect it to affect both wash and dry.
unless the pump is overheating and shutting down.
On wash pump is used for short bursts but on dry its used more as programme last longer

try running a dry programme with no clothes in and see what happens. put a pan of water in the drum before you start and see if it pumps that out at the start of the programme

Dave

Re: Miele WT2670 water in drum after dry cycle

i had problems with a miele not draining intermittently there is an air bleed hose which comes from the pump to the dispenser it was blocked so got air locks in pump and it wouldn’t drain worth a look may have to remove side panel good luck.
geoff.