whirlpool ADP 5962 stopped. no fault lights

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › whirlpool ADP 5962 stopped. no fault lights

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • June 25, 2017 at 2:12 pm #91523
    baker9512
    Participant

    Hi.
    I have a Whirlpool ADP 5962 dishwasher which ran through its cycle last night fine. I have come to use again & noticed there are no lights on the front of the machine. I have checked mains voltage is present to the control board at the bottom. The programme selector lights & usual fault light dont light up.
    Is there an easy way to determine if the control board is faulty or the pcb in the door?. I have checked door switch. Nothing looks burnt or damaged on either pcb. Just wondering if worth bothering with given age of machine.

    June 25, 2017 at 3:14 pm #448433
    electrofix
    Moderator

    Re: whirlpool ADP 5962 stopped. no fault lights

    check wiring going from the door to the chassis for breaks

    remove and replace connectors on the cable between the board in case of bad connection

    Dave

    June 25, 2017 at 6:03 pm #448434
    baker9512
    Participant

    Re: whirlpool ADP 5962 stopped. no fault lights

    Checked continuity between cable plugs. All cores ok. Only getting voltage on mains cable in & out of selector switch. Nothing on 12v circuit.

    June 25, 2017 at 9:24 pm #448435
    electrofix
    Moderator

    Re: whirlpool ADP 5962 stopped. no fault lights

    sounds like a main board power supply fault

    Dave

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.