whirlpool ADP 5962 stopped. no fault lights

[baker9512]

Hi.
I have a Whirlpool ADP 5962 dishwasher which ran through its cycle last night fine. I have come to use again & noticed there are no lights on the front of the machine. I have checked mains voltage is present to the control board at the bottom. The programme selector lights & usual fault light dont light up.
Is there an easy way to determine if the control board is faulty or the pcb in the door?. I have checked door switch. Nothing looks burnt or damaged on either pcb. Just wondering if worth bothering with given age of machine.

[electrofix]

Re: whirlpool ADP 5962 stopped. no fault lights

check wiring going from the door to the chassis for breaks

remove and replace connectors on the cable between the board in case of bad connection

Dave

[baker9512]

Re: whirlpool ADP 5962 stopped. no fault lights

Checked continuity between cable plugs. All cores ok. Only getting voltage on mains cable in & out of selector switch. Nothing on 12v circuit.

[electrofix]

Re: whirlpool ADP 5962 stopped. no fault lights

sounds like a main board power supply fault

Dave

[Author]

Posts