Bosch SMV50C00GB stops after filling with water

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Bosch SMV50C00GB stops after filling with water

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 8, 2017 at 12:09 pm #91857
    PCh
    Participant

    I have a Bosch SMV50C00GB dishwasher that has developed a fault. When switched on it starts to fill with water as usual but after a while beeps five times (c.3 seconds between beeps) and stops working. Opening the dishwasher at this point, the base is full of cold water which then has to be manually baled out.

    I have tested this three or four times and it does the same thing every time. Any ideas? Thanks in advance.

    August 8, 2017 at 12:39 pm #449499
    Martin
    Participant

    Re: Bosch SMV50C00GB stops after filling with water

    PCh wrote: Opening the dishwasher at this point, the base is full of cold water which then has to be manually baled out.

    When this fault occurs will it not drain out using the program reset function?

    August 8, 2017 at 8:32 pm #449500
    PCh
    Participant

    Re: Bosch SMV50C00GB stops after filling with water

    No it doesn’t seem to drain out after resetting. There is some sound of water being pumped somewhere after a reset but it stops quite quickly and the bottom is still full of water

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.