- This topic has 3 replies, 3 voices, and was last updated 8 years, 7 months ago by
.
-
Posts
-
Hi, I have a Beko Integrated machine (WMi81341 7178482100 )
It had stopped spinning. Looked at motor brushes and both were a decent length and the motor commutater is in good condition. Put it back together and selected spin progamme, it worked fine. Did 1 load and it again was fine. Next load, no spin.
Got clothes out of machine, selected spin programme and again it span…
The load seemed normal to me and a typical one that i’d normally run.
Any suggestions for a place to start as it’s not brushes and don’t think it’s an unbalanced load.
Thanks in advance for any help…Re: Beko WMi81341 Spin issues
Thanks for the reply, did check that too, that was fine and waste pipe was ok too…
Thanks Dave…Re: Beko WMi81341 Spin issues
Could be worth a look at the air trap chamber. look for the pressure switch, the thing that controls the water level, follow its thin hose down and you`ll find the air trap. It might be part blocked. If so the machine would over fill but not necessarily enough to cause a flood / error code, the air on pump out does not escape even though the machine has pumped out = the machine still thinks it has water in it = no spin.
- You must be logged in to reply to this topic.