hoover wdryer wdyn458a

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hoover wdryer wdyn458a

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • September 15, 2017 at 2:39 pm #92171
    adv
    Participant

    hi guys just been to this e11 fault was hoping to see the drier wires broken seem fine ,, the sensor state …am getting a ready only on the highest ohms scale 2000k of about 100 . is that normal ? if is ? what else could it be ? pcb ❓

    September 15, 2017 at 5:14 pm #450474
    adv
    Participant

    Re: hoover wdryer wdyn458a

    reading mean sorry

    September 15, 2017 at 5:52 pm #450475
    kaibart
    Moderator

    Re: hoover wdryer wdyn458a

    E11 fault open circuit heater ntc probe and or module that’s what the error code means

    September 15, 2017 at 5:57 pm #450476
    adv
    Participant

    Re: hoover wdryer wdyn458a

    yeh but what does the probes resistance read if ok

    September 15, 2017 at 6:01 pm #450477
    adv
    Participant

    Re: hoover wdryer wdyn458a

    so your saying the probe is only faulty if open circuit then ?

    September 15, 2017 at 6:48 pm #450478
    kaibart
    Moderator

    Re: hoover wdryer wdyn458a

    I’ve put exactly what’s on Hoover’s service error code list my sure ntc should read about 28kohms. Only faults I’ve had on these are blocked condenser and the fan motor coming loose on upper housing.

    September 15, 2017 at 8:07 pm #450479
    adv
    Participant

    Re: hoover wdryer wdyn458a

    ok cheers ..looked on connect. model doesnt even register. qualtex here ..sensor not listed even on hoover site mmmm strange..aaahhh through too feck then

    September 15, 2017 at 8:35 pm #450480
    kaibart
    Moderator

    Re: hoover wdryer wdyn458a

    It’s the wrong model number thats why 3 listed wdyn854dg-86s wdyn854db-80 wdyn854d-80 sensor should be the same on all 3 models will pm you some info kai

    September 15, 2017 at 8:57 pm #450481
    adv
    Participant

    Re: hoover wdryer wdyn458a

    😡 thats off front of machine.. weird took photo // although didn’t check label in door …. mmmm if things arnt hard enough .. putting dodgy model nos on faciers .. :eeek:

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.