ZDC37200W Synthetic Cycle overheating

Home › Forums › Public Support Forums › Help And Support › Tumble Dryer Help Forum › ZDC37200W Synthetic Cycle overheating

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 1, 2017 at 9:21 am #92279
    Wizz
    Participant

    Hi,

    I have a Zanussi ZDC37200W condenser dryer which has started getting too hot on the synthetic cycle. I presume that there must be a thermostat somewhere but so far I’ve not been able to locate one. I’ve had the lid and back cover off and made sure that everything is clean and free from dirt and fluff. Please can someone give me some guidance on where and what to look for?

    Many thanks,
    Wizz

    October 1, 2017 at 12:08 pm #450782
    electrofix
    Moderator

    Re: ZDC37200W Synthetic Cycle overheating

    its in the hot air duct if you take the right side off its near the front

    have you made sure the condenser is clear ?

    Dave

    October 1, 2017 at 3:08 pm #450783
    Wizz
    Participant

    Re: ZDC37200W Synthetic Cycle overheating

    Thank you Dave, I’ve found it now. Am I correct in assuming that this thermostat is probably the culprit and are there any tests I can do to confirm? I’ve checked continuity and that is ok but then that is what I would expect. I’m assuming that it doesn’t switch but then without taking the control board out I can’t find a point that I can monitor. Is it actually a thermistor and if so what should be it’s default resistance value?

    Many thanks,
    Wizz

    Wizz

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.