- This topic has 3 replies, 3 voices, and was last updated 7 years, 11 months ago by
.
-
Posts
-
Morning,
I have a F14 fault on the above dishwasher, the heater pressure switch has been changed, the water level is good and the reed switch tested ok.
The circulation pump runs for about 10 seconds and then pauses and then repeats this series for around 5 mins before the fault code pops up, the capacitor tested ok and the water is being distributed when the motor runs for the few seconds.
I am stumped, any Miele experts out there who could give me a steer on this one.
Many thanks
Jim
Re: Miele G5141 Dishwasher
this tech manual off manualslib cover the American units of the G5 series units
whilst things may differ slightly some of the info should be common
hope it helps
Dave
Re: Miele G5141 Dishwasher
You will normally find a bit of plastic or jam jar label stuck in the circulation motor.
Not too bad a job.
Lay on its side.
Base off.Careful with the hoses as you don’t want to damage them.
I find these easier to do than most.Charge well though as Miele would probably quote f
£150 – £200.
- You must be logged in to reply to this topic.