Miele G5141 Dishwasher

[Jantech]

Morning,

I have a F14 fault on the above dishwasher, the heater pressure switch has been changed, the water level is good and the reed switch tested ok.

The circulation pump runs for about 10 seconds and then pauses and then repeats this series for around 5 mins before the fault code pops up, the capacitor tested ok and the water is being distributed when the motor runs for the few seconds.

I am stumped, any Miele experts out there who could give me a steer on this one.

Many thanks

Jim

[electrofix]

Re: Miele G5141 Dishwasher

this tech manual off manualslib cover the American units of the G5 series units

whilst things may differ slightly some of the info should be common

hope it helps

Dave

[timdowning]

Re: Miele G5141 Dishwasher

You will normally find a bit of plastic or jam jar label stuck in the circulation motor.

Not too bad a job.

Lay on its side.
Base off.

Careful with the hoses as you don’t want to damage them.
I find these easier to do than most.

Charge well though as Miele would probably quote f
£150 – £200.

[Jantech]

Re: Miele G5141 Dishwasher

Tim/Dave, thanks for the info both excellent, I’m back there tomorrow so will use all you’ve given to get it working!

Have a brilliant weekend

Jim

[Author]

Posts