Beko WM74135 no motor action

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko WM74135 no motor action

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • May 17, 2018 at 2:55 pm #93931
    delta01
    Participant

    hi just fitted carbons to this machine it did not cure the nma i suspect module.
    the machine starts to pump out on spin then stops with12 minutes on display it does not count down any help appreciated thanks John

    May 17, 2018 at 7:40 pm #455936
    suedehead1
    Participant

    Re: Beko WM74135 no motor action

    possibly blew dc module

    May 18, 2018 at 7:02 am #455937
    delta01
    Participant

    Re: Beko WM74135 no motor action

    thanks is that the one on the side is it repairable

    May 18, 2018 at 2:44 pm #455938
    wilf
    Participant

    Re: Beko WM74135 no motor action

    Usually blows the track off. I found that if it’s blown it’s a sure sign that the motor is u/s Look for any tell tale signs on the com or brush holders. I wont fit a new pcb and risk blowing it as it’s quite a hit. A Beko engineer told me that they never change one without a new motor, but out of guarantee that’s BER.

    regards wilf

    May 20, 2018 at 11:34 am #455939
    delta01
    Participant

    Re: Beko WM74135 no motor action

    thanks for input wilf i repaired tracks on module motor it now goes up to full speed then stops i ordered a s/h module so will try that i think it blew because one brush was right down i cant see any obvious motor problems

    May 20, 2018 at 6:15 pm #455940
    electrofix
    Moderator

    Re: Beko WM74135 no motor action

    check the tacho magnet on the back of the motor

    if they break the motor accelerates but with no feedback the module shuts it down

    Dave

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.