- This topic has 2 replies, 2 voices, and was last updated 7 years, 8 months ago by
.
-
Posts
-
ic: 76407350000
This display board hasn’t come back on after a power cut but appliance seems to be working ok. I guess it’s operating in default mode.
Before I go to this, is there a fuse on the power board- display board circuit or am I looking at a new display board?
I only have access to parts diagram.
TIA DarrellRe: hotpoint ff200mx display board dead
all the display board I have seen are not fused. they will only be fed with 12v or so from the power board. if the display board is part functioning look at display with a torch. may be the back lights are off if its LCD, got a hotpoint dryer with that problem. If its only display off then maybe a blown resistor on display panel. if other functions of the panel function ok then most likely only the display
but bear in mind , they are powered from the main board so it may be a display fault or a power board fault or both
Dave
- You must be logged in to reply to this topic.