Diplomat ADP8500

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Diplomat ADP8500

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • August 16, 2018 at 2:23 pm #94456
    1totalshambles
    Participant

    Hi. Had a look a previous posts on this machine but somewhat inconclusive.
    The issue is: turn to any programme and the machine pumps then goes to fill. It is a pulsed fill when it shouldn`t be. The wash motor will not run, the machine carries on filling but I didn`t let it get too high to save a possible flood. I thought the wash motor maybe / may still be the problem so I tried the whole exercise 4 times then swt`d off and felt the wash motor stator…it was cold so presume wasn`t getting power. The draid pump works when the programme is aborted / cancelled. The l/h/side chamber reed contact and impellor seems to work ok, 5 volts`ish .
    Any suggestions please?

    August 16, 2018 at 7:30 pm #457410
    1totalshambles
    Participant

    Re: Diplomat ADP8500

    ADD.
    The built into the sump pressure switch is spotless. Read drain pump works……. rather than draid pump works…….!

    August 16, 2018 at 10:33 pm #457411
    electrofix
    Moderator

    Re: Diplomat ADP8500

    not on a good internet connection at the mo but from memory. Check the timer power supply if it uses capacitor to drop voltage to power board change it


    Dave

    August 17, 2018 at 5:26 am #457412
    1totalshambles
    Participant

    Re: Diplomat ADP8500

    Thx for reply.
    In other words there is a capacitor on the pcb that may have gone wrong. If it has change that capacitor. I`ll have a look before my usual blundering around. Cheers.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.