- This topic has 9 replies, 3 voices, and was last updated 7 years, 7 months ago by
.
Viewing 10 posts - 1 through 10 (of 10 total)
-
Posts
-
dcu7230w put it on ex dry, it drys fine but stays on drying, does not move down the lights to end, keeps going, thinking its the pcb?
Re: beko dryer
check both NTC
check customer is not using dryer sheets like bounce as these can coat sensor
check sensor is clean
test prog will let you test sensor is connected and other things
Dave
Re: beko dryer
So did the test and wont get past spet 2 senor closed circuit, cleaned sensor and the ntc is ok so does that mean the board?
CheersRe: beko dryer
means board is sensing the sensor is not open circuit as it should be with no washing in
check wiring to sensor and sensor its self for possible problemsDave
Viewing 10 posts - 1 through 10 (of 10 total)
- You must be logged in to reply to this topic.