- This topic has 6 replies, 3 voices, and was last updated 7 years, 6 months ago by
.
-
Posts
-
Hi guys, I’ve not been busy much, trying to cope with being the house husband and all.serious deterioration in the area of my operation. Anyway, if anyone can help I would be grateful. WMFUG742 Repair manual for wiring instructions for the door interlock as my pals has melted.
Going to pop over and see an old Army colleague later this morning, Thanks chaps.
ChrisRe: Hotpoint machine with melted door interlock
if the connection blocks burnt out just do a one for one wire swop using standard amp tags putting an insulated one in the middle. not that uncommon.
regards wilf
ps I dont think your the only one short of work!
Re: Hotpoint machine with melted door interlock
Hi Wilf the block is disintegrated getting it out was a complete nightmare. The connections are loose and free hanging.
Re: Hotpoint machine with melted door interlock
You will have to meter out the new interlock but its usually neutral thin red to number three. But dont take my word for it and there are two different types of lock on that machine.
wilf
Re: Hotpoint machine with melted door interlock
It’s a WMFUG720P UK.M 85931760000
2 wires melted into one and the pins on what was left of the interlock are historyRe: Hotpoint machine with melted door interlock
New lock is C00309745 PTC type for 40CM doors. The connection numbers depend on brand of lock supplied, usually 2,3&4 or 3,4&5 on the Bitron locks
PTC is on 2 (Bitron 3) — As Wilf notes this is the thin wire
Common is on 3 (Bitron 4)
Switch is on 4 (Bitron 5)Regards, Murv…
- You must be logged in to reply to this topic.