Tumble Dryer Wiring

Home › Forums › Public Support Forums › Help And Support › Tumble Dryer Help Forum › Tumble Dryer Wiring

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • January 31, 2019 at 7:33 pm #95415
    stender
    Participant

    Hi All, I have changed the heating unit on my hotpoint tvf770 but when going to plug the connectors into the unit have found that i didnt know where to plug the red and black power connector. I wrongly assumed it would be one way andplace but there are a couple of green circuit board locations. I took a guess and it tripped the electric. I then turned it around the other way and the dryer started ok but when i returned it was flashing all lights with a F10 fault and it hadn’t got hot. I then removed it again and not sure now where to connect it to. I’m also hoping I havent blown anything else. I cant find a picture of the connections anywhere.

    February 4, 2019 at 2:21 pm #460288
    iadom
    Moderator

    F10 is an open circuit in the heater common wiring.

    Check module connector J4;
    • Check wiring between module connector J4 and the heater;
    • Test heater elements.

    Sadly it points to a blown module. 🙁

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.