Hotpoint FDYB11011P dishwasher

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint FDYB11011P dishwasher

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • May 6, 2019 at 3:16 pm #95832
    chuffy
    Participant

    Have just replaced the heating element on this appliance but still getting original error code……salt and rinse light flashing and drying light illuminated.
    How can I clear this error code?
    Thanks in advance.

    May 6, 2019 at 9:13 pm #461484
    electrofix
    Moderator

    well the error I read from this is not a heating error but a water error

    Dave

    May 8, 2019 at 11:05 pm #461485
    chuffy
    Participant

    Hi Dave,

    Thanks for the response but my research indicated it was a (a10) heating fault and the heating element was indeed open circuit.
    This was subsequently replaced and but the same error lights persisted and I couldn’t start a programme.
    I have since managed to reset the error by more luck than anything else by switching on/off whilst holding in various buttons.
    The appliance is now working perfectly but I would like to know how to do a reset for any future repairs on these appliances.

    Cheers.

    Noel.

    May 8, 2019 at 11:28 pm #461486
    electrofix
    Moderator

    cant see any specific reset procedure

    Dave

    May 12, 2019 at 6:05 am #461487
    baron
    Participant

    electrofix wrote:cant see any specific reset procedure

    Dave

    Just by starting test procedure. At first step is showing the erorr and at the end of test program error will be cleared or by reprogramming board…

    June 4, 2019 at 12:09 pm #461488
    chuffy
    Participant

    Ok but how do you initiate a test procedure?

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.