Build in kit for Miele G4210 Dishwasher

Home › Forums › Public Support Forums › General Enquiries And Questions › Build in kit for Miele G4210 Dishwasher

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • July 29, 2019 at 4:40 pm #96193
    Fatmoggy
    Participant

    We’re having a new kitchen installed. We currently have a Miele G4210 freestanding dishwasher. The instruction manual says there is a build in kit available, but when I rang Miele, the woman I spoke to didn’t seem to know what this entailed. Basically I just wanted to find out if there is some way of physically raising the machine so the dishwasher door lines up with the units. The units are white so I don’t need to attach a door panel. G4210 is about 6 years old, works perfectly. The instructions also mention a build in plinth is available. Appreciate any feedback.

    July 29, 2019 at 7:27 pm #462650
    electrofix
    Moderator

    well there is no reason you cant put strips of wood under the legs

    Dave

    July 30, 2019 at 9:21 am #462651
    Fatmoggy
    Participant

    Cheer Dave. I have done that previously with an old Bosch dishwasher. The front kick plate could be remove and the front feet then screwed in further back allowing a continuous plinth to run across. I just wondered what the Miele build in kit comprised of. Lady from Miele didn’t seem to know either!
    Rob.

    July 30, 2019 at 11:08 am #462652
    electrofix
    Moderator

    bosch did one but it was a plate that allowed you to take the top off and replace it with a thin metal sheet. This lowered the machine by about 25mm or so to allow it to fet under a low worktop

    Dave

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.