- This topic has 3 replies, 3 voices, and was last updated 20 years, 10 months ago by
.
Viewing 4 posts - 1 through 4 (of 4 total)
-
Posts
-
I have replaced the control board correctly in this machine but the 15 stages of programing does not look the same on the chart i.e. light on light off etc
Position 1 to 8 is correct but 9 to 15 is wrong.
Could this be a faulty board?
I have run a test prog and the END light flashes about 2 minutes into the test
Has anybody any idea?Re: Hotpoint WMA35S
why did you change the board – what was the fault?
and have you definately followed the model configuration?
clyde 8)Re: Hotpoint WMA35S
The board and motor was changed because the motor blew the board.
I have followed the instructions the the letter.
I have changed about 200 of these with no problem but this one has got me stumped.
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.