Hotpoint WMA35S

[raider6723]

I have replaced the control board correctly in this machine but the 15 stages of programing does not look the same on the chart i.e. light on light off etc
Position 1 to 8 is correct but 9 to 15 is wrong.
Could this be a faulty board?
I have run a test prog and the END light flashes about 2 minutes into the test
Has anybody any idea?

[clyde]

Re: Hotpoint WMA35S

why did you change the board – what was the fault?

and have you definately followed the model configuration?

clyde 8)

[raider6723]

Re: Hotpoint WMA35S

The board and motor was changed because the motor blew the board.
I have followed the instructions the the letter.
I have changed about 200 of these with no problem but this one has got me stumped.

[iadom]

Re: Hotpoint WMA35S

raider6723 wrote:
I have changed about 200 of these with no problem but this one has got me stumped.

200 !!!!! I think you are in the wrong forum. 😉

[Author]

Posts