Siemen Integrated Microwave Issue

Home › Forums › Public Support Forums › Help And Support › Cooker And Oven Forum › Siemen Integrated Microwave Issue

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • December 8, 2019 at 10:30 pm #96850
    Manhattan24
    Participant

    Hi,

    Unfortunately while using my Microwave today it just stopped midway through with a complete loss of power. I replaced the fuse in the plug but that didn’t do any good. I just wondered if the internal fuse might need replacing or if there was anything else I could do to try and fix it? If it isn’t worth repairing, any advice on a suitable similar replacement would be very much appreciated.

    The Microwave is Siemen Model No. HF-25M560B/02

    Thanks

    December 9, 2019 at 12:04 am #465034
    electrofix
    Moderator

    you could try the internal fuse anything else is a professional job

    Dave

    December 9, 2019 at 12:50 am #465035
    Manhattan24
    Participant

    Thanks for the reply.

    I shall try a new fuse in it and hopefully that will do the trick. I think the microwave might have shorted out because I was warming plates in it, but I did put a small bowl of water in at the same time.

    December 9, 2019 at 1:30 am #465036
    electrofix
    Moderator

    you cant warm plates in a microwave they only heat water so yes you may have destroyed it

    Dave

    December 10, 2019 at 6:27 pm #465037
    Manhattan24
    Participant

    I managed to get the cover off the microwave, but couldn’t locate the fuse. I just wondered if you had any ideas where to look for it? The power cord is at the bottom of the machine, so I would assume it wouldn’t be far from there. I did try to find a diagram or service manual but couldn’t find anything on Google. Also, video guides on YouTube all seem to be non-integrated machines.

    Thanks

    December 10, 2019 at 8:39 pm #465038
    electrofix
    Moderator

    cant find it on any parts lists

    follow the cable in and see where it goes

    check door switch unit and main board

    there is also sometimes a small board to filter out interference on some microwaves

    Dave

    December 14, 2019 at 4:40 am #465039
    Manhattan24
    Participant

    Thanks for the advice.

    Unfortunately after removing all visible screws on the back of the machine the panel seems completely immovable. It looks like it’s connected to the top and front, which I think would require dismantling. Before giving up and buying a new one, I thought I would post a few images that perhaps you could look at to see if there was an easier way to find the offending fuse.

    Link to photo – https://ibb.co/82WcMkB

    December 14, 2019 at 10:11 am #465040
    electrofix
    Moderator

    most of the front panels once unscrewed lift up to unlock then lift off

    Dave

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.