- This topic has 5 replies, 2 voices, and was last updated 6 years, 2 months ago by
.
-
Posts
-
looking for some help I took ownership of above maching and it keeps filling up the base of the maching ive clened the punp. Taken the pump put checked the non return valve removed the inlet solenoid valve. adjusting the pressure switch and still keeps filling up the base it look like clean salty water any thing else to check or do before i replace the machine ?
If it was filling the base you would get lights flashing an error message. Do you mean filling the inner tub when not in use?
Not sure what you mean by ‘removed inlet solenoid valve’, as this is one of the likeliest causes of the fault did you replace it?
iadom wrote:If it was filling the base you would get lights flashing an error message. Do you mean filling the inner tub when not in use?
Not sure what you mean by ‘removed inlet solenoid valve’, as this is one of the likeliest causes of the fault did you replace it?
I don’t get any flashing lights error message on the front. The bit that filling up with water is where the plates bowls ect go in from the base pump area i took the intet solenoid out and left it i a bucket over night and did not leak at all if that helps also put the drain out incase it was back fiilling and wasn’t any no replacment parts yet looking to find the right part to replace first
If it is filling into the inner tub when not in use with the drain hose uncoupled from the plumbing then it can only be a faulty inlet valve.
- You must be logged in to reply to this topic.