Smeg Dishwasher DWD612CSS Panel

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Smeg Dishwasher DWD612CSS Panel

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • February 22, 2020 at 2:27 pm #97241
    Allan12
    Participant

    When I press the power button the power light briefly lights and then fades. I cannot start any washing programmes. Any ideas of what is wrong please?

    February 22, 2020 at 8:31 pm #466639
    kwatt
    Keymaster

    |Have checked the supply is okay?

    After that, mains filter then mins switch, then you get into the more difficult stuff.

    K.

    February 22, 2020 at 9:08 pm #466640
    Allan12
    Participant

    Hi Kwatt

    I know the power supply is fine because I can hear the solenoid is working. The dishwasher is near to our main water supply inlet and causes a small bit of water hammer. Sorry for the stupid question but how do I check the mains filter and mains switch without replacing them?

    February 22, 2020 at 11:47 pm #466641
    kwatt
    Keymaster

    The mains switch is usually reasonably simple as that’s just a make/break switch effectively for more, the format varies but the same idea on all.

    It’s this: https://shop.ukwhitegoods.co.uk/816450164-smeg-dishwasher-power-switch

    Simply metering it will test if it’s okay. All it does is make or break.

    The mains filter is really a capacitor in disguise and if they got there usually evidently failed but I do think that’s a long shot here. That said, it’s not an uncommon thing to fail, this kind part is what you’re looking for but the format can vary:

    https://shop.ukwhitegoods.co.uk/813410489-mains-interference-filter

    Or : https://shop.ukwhitegoods.co.uk/813410094-smeg-dishwasher-mains-suppressor

    Door switch, maybe.

    But from what you’re saying, if it’s trying to fill and not, the valve needs checking as well.

    After that though your into checking the recric pump, boards and stuff so it gets a lot harder.

    K.

    February 23, 2020 at 3:53 pm #466642
    Allan12
    Participant

    Hi Kwatt

    Thanks for the info. I haven’t got a test meter, but power must be getting through otherwise I wouldn’t hear the solenoid. It isn’t trying to fill, I’m not getting that far. I’m assuming it must be a problem with control panel, otherwise I would be getting a series of power lights showing an error code. I press the power switch, hear the solenoid move and then nothing.

    Regards

    Allan

    February 23, 2020 at 5:11 pm #466643
    kwatt
    Keymaster

    Possibly but that’s not an easy machine for beginners as it’s’ got three boards in it if memory serves.

    But it should clear the sump first so, are you hearing the pump running or a valve? After it clears the sump then it’ll fill. Then it’ll start to wash and heat.

    The trick is working out what bit of that it’s not doing.

    K.

    February 23, 2020 at 9:47 pm #466644
    Allan12
    Participant

    Hi Kwatt

    Thanks for all your help, it’s a bit complicated for me and I haven’t got the equipment, so I’ll get an engineer to have a look at it.

    Allan

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.