- This topic has 4 replies, 2 voices, and was last updated 6 years, 1 month ago by
.
-
Posts
-
We have a Miele G4263 SCVi which had a major flood into the drip tray – just the drip tray but lots of water from the discharge pipe (repaired now).
This caused arcing on the heater relay small control board module which has now been replaced.
The display at the top of the door is now dead – no response from the buttons, no leds are lit etc.
If we lift the float, the pump still runs so there is some control voltage present.
I am looking for inspiration or a wiring diagram if possible – or some pointers from others hereMany thanks for looking at this post.
well the fact its dead would mean the forst place to start is the main power board
manuals and wiring are hard to get for miele you could search manualslib to see if there is any info that may help
Dave
Thanks Dave,
I trawled manualslib without success.
I’m assuming the main board will be in the upper part of the door?Cheers
you will prob find similarities in this one
https://www.manualslib.com/manual/1333124/Miele-G-4205.html?page=21#manual
Dave
- You must be logged in to reply to this topic.