Integtrated Diplomat (Servis) APM8512 vibration

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Integtrated Diplomat (Servis) APM8512 vibration

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • May 23, 2005 at 2:40 pm #9742
    andy2
    Participant

    Hi – Been to one of these today, the m/c has a really bad (high frequency) vibration on spin

    Everthing looks OK but thought it might be worth replacing the dampers.

    This machine is on a chipboard floor (bad) but it has been installed for a while with no problems until lately, the guy said it does it on all loads so pretty much rules out OOB load probs.

    Wotcha reckon?

    Andy 🙂

    May 23, 2005 at 8:48 pm #135619
    kwatt
    Keymaster

    Re: Integtrated Diplomat (Servis) APM8512 vibration

    This isn’t something we’ve seen a problem with after the initial installation Andy and we’ve seen a few.

    I take it that it’s the one with the damper pads (from memory it is, but I don’t have the info here at home) as if that’s the case the only thing I can suggest is to replace the pads and see how it goes. Never replaced springs on one of these in my puff.

    K.

    May 23, 2005 at 9:42 pm #135620
    andy2
    Participant

    Re: Integtrated Diplomat (Servis) APM8512 vibration

    Hi Ken

    No it uses the shock absorber type dampers PN:499003200 which is why i thought they might be the prob. They could be duff but there is nothing to see as such.

    Told the guy I would fit new ones at his request but couldnt guarantee it would solve the problem. But to be honest I don’t like working on this kind of basis.

    May 23, 2005 at 9:45 pm #135621
    kwatt
    Keymaster

    If that’s those cheap plastic things then we’ve replaced a few of those. 😕

    Sorry, that’s what happens when you have a memory like a sieve. 😉

    K.

    May 23, 2005 at 9:48 pm #135622
    flash
    Participant

    Re: Integtrated Diplomat (Servis) APM8512 vibration

    Hi andy every job I have done on diplomat washers it has always been something to do with the bearings or spider it will be worth looking there.


    glen

    May 24, 2005 at 5:06 pm #135623
    andy2
    Participant

    Re: Integtrated Diplomat (Servis) APM8512 vibration

    Thanks guys

    The man was me to do the job so its his decision, i will keep my fingers crossed

    Andy 🙂

    June 9, 2005 at 5:59 pm #135624
    andy2
    Participant

    Re: Integtrated Diplomat (Servis) APM8512 vibration

    Just for future reference

    I fitted two new dampers to this machine and it was running like a little sweety pie when I left.

    Thanks guys. 🙂

    Andy.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.