Beko Dishwasher dl1243apw not filling

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Beko Dishwasher dl1243apw not filling

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • May 3, 2020 at 7:47 pm #97568
    Askabar
    Participant

    hi, hope you can help.

    A few days our dishwasher has stopped filling. When I start the cycle, it starts to empty and then it should fill. I immediately thought it was the inlet valve which I replaced anyway with a new one. This did not fix the problem.
    The float switch is on the bottom tray which was dry. I have checked the the float switch and there does seem to be a change in ohms when I use a multimeter when I depress the switch which seems like it is not faulty either.
    I have tried to empty as much of the water out of the salt dispenser just incase.
    I am out of ideas so any help is appreciated.

    Not sure if this is relevant but the salt light on the front panel is not red anymore. I don’t use salt, never have, as I use all in one tablets.

    Please help

    Jason

    May 3, 2020 at 8:34 pm #468430
    electrofix
    Moderator

    I would check the wires as they leave the bottom of the door as they can break

    Dave

    May 3, 2020 at 8:45 pm #468431
    Askabar
    Participant

    I have taken the front panel off and I cannot see any loose wires or anything.

    May 3, 2020 at 9:16 pm #468432
    electrofix
    Moderator

    its not loose wires your looking for
    follow the wires to the bottom of the door, where they leave the door they bend every time the door opens and closes. They have a habit of breaking at this point

    you can look for physical breaks or use a multimeter to see if the wire is intach from the vlave to the board

    Dave

    May 3, 2020 at 9:23 pm #468433
    Askabar
    Participant

    Hi Dave.

    Not sure what has happened know but all I get in the front panel is one light, the on/off light. It will not start at all now guessing the board has fried.

    Maybe best just to move on and get another.

    Jason

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.