- This topic has 2 replies, 3 voices, and was last updated 5 years, 10 months ago by
.
-
Posts
-
Hi
i was hoping someone can help me I have a few Hotpoint main circuit boards and have no idea what models they have been setup to run, does anyone know where I can get the equipment to reset the boards so I can either use them or sell them on.
Kind regards
Michael
The short answer is no because Hotpoint have so many variations on the same looking pcbs without a model number it is near impossible to do yourself
As Kai says it not something thats worth doing
to be able to sell the boards on you would not only have to match the model number you would have to match the commercial code as you can get the same model with different software. you would have to be able to power the boards up and have not only the programming equipment but access to the correct firmware for the machine your trying to fit it toIts not worth it unless your doing the job as a professional and even then its doubtful
Dave
- You must be logged in to reply to this topic.