- This topic has 2 replies, 2 voices, and was last updated 5 years, 9 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
the element had a insulation fault changed element customer rang me to say it appeard to do the wash then stopped at rinse with e03 i asked her to put it on spin but would not start with fault code e16 coming up again any ideas please before i go back
e3 is water drain
E16 is heater faultyou need to check if its blown the new heater. if yes suspect pressure switch or board relay
Dave
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.