- This topic has 2 replies, 3 voices, and was last updated 5 years, 8 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
hi all hope everyone is keeping well in these times, this one pnc 91460330200 , s showing E22 , i take it its the ntc in the condenser hose to the tub , im getting a reading of 4.7k ohm , the condenser and recirculating pump were completely blocked , anyone have a part no thanks Kieran
Here is what the manual says about that code:
E22:
Difficulty in water fill during drying or drying condenser clogged (anti-boiling pressure switch closed on “FULL”) – Drain hose kinked; filter clogged: drying condenser clogged; drain pump faulty; pressure switches faulty; wiring; main circuit board defective; current leakage between heater and ground.
The sensor reading looks to be about right as it says in the book 5K at 25C
Jem
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.