Siemens dishwasher

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Siemens dishwasher

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • August 10, 2020 at 8:52 am #98148
    ChrisR
    Participant

    Good morning.
    I replaced the drain valve on this dishwasher a few days ago but the E19 code has returned.
    Dishwasher stopped short of completing the programme leaving warm water in the bottom and not draining.
    Customer has since done a short programme and water has drained correctly.
    Any suggestions?.
    Thanks very much.
    Chris.

    August 10, 2020 at 5:45 pm #471086
    electrofix
    Moderator

    have you checked the wiring back to the timer from the valve ?

    Dave

    August 10, 2020 at 8:32 pm #471087
    ChrisR
    Participant

    The dishwasher worked fine for three washes after fitting the drain valve then e19 came up again.
    I’ll be going back in a couple of days so I’ll check board connections and the cabling to the valve.
    Have you come across this before Dave?.
    Thanks for the input.
    Chris.

    August 10, 2020 at 8:51 pm #471088
    electrofix
    Moderator

    not had a repeat fault
    you could check the new coil for failure, long shot i know


    Dave

    August 11, 2020 at 6:10 am #471089
    ChrisR
    Participant

    Cheers Dave

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.