- This topic has 9 replies, 4 voices, and was last updated 5 years, 7 months ago by
.
-
Posts
-
HBN9151GB/06. the main oven only heats to about 180 degrees I fitted a new element and thermostat and it is still the same,
the fan is going . any ideas welcomedyou say it heats to 180 and stops How ?
does the stat switch off ?
does the stat and motor switch off ?its a simple system so cant be a lot
how are you measuring the temp and what have you got it set to ie 200 220 ?
Dave
have you checked the knob is fully operating the stat i.e the actual temprature against the set temprature.
wilf
Hi,
I move the knob to 100 then 150 light goes off i turn it to about 180 it never gets that hot . I can see the element glowing red but beforeit gets to 180 the element goes off the fan motor keeps running and it starts to cool down the knobgoes onto a switch which turns the stat all operatingok.i assume the sensor is in the correct position and the correct stat is fitted 00489378
if your using an oven temperature guage put is as close to the sensor as you can get it and see what you get
Dave
well i cant figure anything that you have got wrong
unless its a faulty stat then a bit out of ideas now
Dave
It looks like it has 2 cooling fans – are either/both running (especially the one located between the 2 ovens)? If not it could be tripping the chassis overheat cut out on the back of the oven.
Jem
- You must be logged in to reply to this topic.