hotpoint tvfs83 dryer Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint tvfs83 dryer This topic has 7 replies, 2 voices, and was last updated 5 years, 7 months ago by eng14. Viewing 8 posts - 1 through 8 (of 8 total) Author Posts September 9, 2020 at 3:26 pm #98321 eng14Participant hi all went to this dryer this morning,both stats gone changed them and worked for some time heating, now heat gone again,thanks richard September 9, 2020 at 5:16 pm #471826 electrofixModerator would need more info to look it up as the above narrows it to 20 machines have the stats gone again ? Dave September 10, 2020 at 7:01 am #471827 eng14Participant yes dave,richard September 10, 2020 at 8:03 am #471828 electrofixModerator let me have all the model details so i can look it up to see if there is any probllems highlighted Dave September 10, 2020 at 3:36 pm #471829 eng14Participant thanks dave just got in,tvfs83cgp September 10, 2020 at 7:09 pm #471830 electrofixModerator still have to assume a few things 1 that the model is TVFS83CGPUK there are other similar machines and you dont give me the commercial code to double check if above is correct then the stat kit should have been C00112196 did this fail while you were watching ? if no could the cap be getting weak stopping it revolving ? Dave September 11, 2020 at 3:01 pm #471831 eng14Participant hi dave thanks no we went and 4hrs later it failed,i suspect thermistor overheating.is that possible to knock out the new stats,regards richard arg. September 11, 2020 at 9:39 pm #471832 electrofixModerator the thermistors both front and rear control the temp both leaving the heater and leaving at the front of the dryer so yes they can be a source of failure assume since its a vented dryer you have checked the vent to outside Dave Author Posts Viewing 8 posts - 1 through 8 (of 8 total) You must be logged in to reply to this topic. Log In Username: Password: Keep me signed in Log In