lamona 8601 dishwasher

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › lamona 8601 dishwasher

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • October 14, 2020 at 1:21 pm #98478
    mikehha
    Participant

    can any one shine a light on why I have lights 3and 4 flashing cant seem to find the fault code many thanks.

    October 14, 2020 at 5:26 pm #472560
    electrofix
    Moderator

    no there are no fault codes for that

    have emailed you the test routine

    Dave

    December 23, 2020 at 8:32 am #472561
    mikehha
    Participant

    Thanks for that dave it turned out to be module. Now I have a LAM 8601 with the 2 and 3 light flashing and while they are flashing you can`t get it into a test cycle I can not find the code for this also. But if you leave it for a couple of days you might get one wash out of it before the lights flash again, there is no water in the base and pressure switch is fine. anyone know this or have come across this fault . thanks

    December 23, 2020 at 10:19 am #472562
    electrofix
    Moderator

    have you checked board caps for signs of damage ?

    Dave

    December 23, 2020 at 2:54 pm #472563
    mikehha
    Participant

    yes main module looks ok I know there has been problems with the selector button module but I didn`t think it would throw up this type of fault. could be water damage on top edge of door?

    December 23, 2020 at 8:55 pm #472564
    electrofix
    Moderator

    had lots of problems with water ingressing the buttin modules and so the switches donts work properly

    Dave

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.