Beko Dishwasher din29x20

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko Dishwasher din29x20

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • November 29, 2020 at 7:39 am #98729
    mjhservices
    Participant

    Trips out the mains when plugging in, megger shows short to earth. You would think this would be easy but after disconnecting everything one by one starting with element and motor the short is still there. Have checked wires in the lower door area and they look ok but then this dishwasher is only just over one year.
    Any ideas?

    November 29, 2020 at 9:13 am #473560
    electrofix
    Moderator

    have you checked supressor ?

    is this integrated
    if yes its a 2 year guarentee
    they say you have to register it but you could push them and act dumb


    Dave

    November 29, 2020 at 5:13 pm #473561
    suedehead1
    Participant

    did you check the plug or suppressor I have had a couple of Bekos where the fitted plug had shorted

    November 29, 2020 at 6:21 pm #473562
    mjhservices
    Participant

    Thanks but yes I have checked the plug lead and mains filter along with everything else, this one’s a rear pain.

    November 29, 2020 at 7:04 pm #473563
    kaibart
    Moderator

    Probably the led light that shines onto the floor this has caught me out 😉

    November 29, 2020 at 7:45 pm #473564
    mjhservices
    Participant

    And this has caused the machine to trip out when plugging it in before even turning it on?

    November 29, 2020 at 11:06 pm #473565
    kaibart
    Moderator

    Yes it has water gets in the neon some are available with just the loom fir neon some are complete harness just cut the wires to neon you have nothing to loose as you can remake wires

    November 30, 2020 at 2:58 pm #473566
    mjhservices
    Participant

    Many thanks for your help, it just turns out a came across another one of these today that was tripping out as soon as its plugged in so I went straight to the neon light and you are right. Thank you for your help again.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.