- This topic has 8 replies, 3 voices, and was last updated 5 years, 4 months ago by
.
-
Posts
-
Hi guys , another one of these baby’s god they’re troublesome, E32 error conductimetric sensor short, board , wiring , drum shorcutted, anyone repair this fault, likely to be the board ? Thanks Kieran
you dont list a model so cant look anything up but you seem to have access to tech
have you tried the list of possible faults they list ?Dave
Hi Dave yeah had a look around i can’t see any wiring loose , sensor maybe but it won’t heat on a timed program either 91609737500 cheers
have you check compresor runs in diagnostic mode
assume you have checked for power to the compressor in case its siezed
Dave
I have had a couple of these where the blower motor (mounted in the rear air duct) fan bearings have seized, remember that it won’t “heat” like a traditional dryer so I find that you are better off pulling out the lower filter while it is running to check for airflow and to see if the evaporator is getting cool to the touch.
Jem
- You must be logged in to reply to this topic.