- This topic has 2 replies, 3 voices, and was last updated 4 years, 10 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Our tumble drier (code 916 092 498 0 0, serial 54963026) often stops at the stage when the drum is due to reverse and fails to restart. A gentle tap on the back of the white plastic moulding which houses the pcb assembly makes it restart. Can this fault be resolved easily and at a cost worth paying?
Sounds like either a bad joint or a sticking relay on the PCB. I’d be guessing a relay though. Should be quite easy to fix if you are ok with soldering and can see a part number on the relay..
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.