Zanussi FLE1216W Skipping prog’

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi FLE1216W Skipping prog’

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • June 6, 2005 at 8:43 am #9963
    Seamy
    Participant

    Gotta go out to a Zanussi FLE1216W, which is skipping programme & going to end of programme & spin led flashing, customer says when she selects spin only it will spin, she has cleaned filter & water is getting away, any ideas or pointers would be gratefully recieved.

    Ta
    Sé

    June 6, 2005 at 10:04 am #136983
    Dave_Conway
    Participant

    Re: Zanussi FLE1216W Skipping prog’

    Tacho generator problems by the sound of it Seamy.

    Dave.

    June 7, 2005 at 10:00 pm #136984
    martinatmull
    Participant

    Re: Zanussi FLE1216W Skipping prog’

    Almost certainly tacho gen. Probably find tacho gen coil has fell off motor or magnet unscrewed.

    M :o) (zanussi engineer)

    June 7, 2005 at 10:45 pm #136985
    litlor
    Participant

    Re: Zanussi FLE1216W Skipping prog’

    yes more than likely tacho gen if not check heater ntc had one leaking water and the same fault occurs

    June 8, 2005 at 7:08 pm #136986
    andy_art_trigg
    Participant

    Re: Zanussi FLE1216W Skipping prog’

    Won’t it spin on wash if the tacho coil comes off?

    June 8, 2005 at 7:11 pm #136987
    Penguin45
    Participant

    Re: Zanussi FLE1216W Skipping prog’

    It should kick once, then stop.

    Chris.

    June 8, 2005 at 7:26 pm #136988
    litlor
    Participant

    Re: Zanussi FLE1216W Skipping prog’

    have we got a fault code

    June 17, 2005 at 9:46 am #136989
    Seamy
    Participant

    Re: Zanussi FLE1216W Skipping prog’

    I’ve changed tacgo magnet & new brushes, also cleaned armature, still causing problems, on test if i select spin only,after start (sometimes) you hear door lock, pump starts, hear relay click no motor action, then start led flashes. Tried most prog’s this happens.

    June 17, 2005 at 10:04 am #136990
    Martin
    Participant

    Re: Zanussi FLE1216W Skipping prog’

    I guess the motor and module are not speaking to each other then 🙁

    Its got to be a connection problem and that both ends of the wiring between the 2 need testing I’m afraid. 🙁

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.