- This topic has 2 replies, 2 voices, and was last updated 4 years, 8 months ago by
.
-
Posts
-
Would anyone be able to offer some advice? I have a Hotpoint Aquarius tumble driver model AQC9BF7S1.
It heats up as expected at the start of a cycle but after about 10 minutes the heating part stops but the cycle continues. It will only heat up if I cancel the cycle and start again.
I had thought it was just the thermostats so I have replaced them, no change. I have then bought a replacement kit with the element, thermostat and humidity sensor, once fitting I still have the same issue.
I’m at this point I’m really stuck? could it be the circuit board? I don’t really want to spend anymore money on it asit’s getting very expensive! I was just wondering if you have any advice on how to get this working?
Thanks, Allan
you mean it continues cold ?
how long does it run cold before it decides its the end ?
what i am thinking is it decides its dry enough and goes into the 10 min cool down phase and stops
is the condenser clear both ways, mainly front to back ?
Dave
- You must be logged in to reply to this topic.