- This topic has 4 replies, 3 voices, and was last updated 4 years, 8 months ago by
.
-
Posts
-
Good afternoon all,
Have an obscure fault with the above W/D.
Essentially when on a drying cycle, all is fine for between 15 & 30 minutes prior to the machine stopping and the display failing completely.
Once left for a few minutes the machine recovers, and works again until the above fault recurring.
I’ve had a look at the wiring multi plugs to the three boards, (Operating Module, Control Module & Display Module) which all appear good.
Does anyone know if the above is a known fault, and/or which module it is likely to be? (the Op’ Mod’ & Control Mod’ are both over £200.00 each!)
jontyhave you checked for leaking steam ?
also check dryer element insulation when it fails
or when it fails it normally takes a few minutes to recover. so take the wires off TD elements and see if it recovers
Dave
Thanks gent’s,
Looks like a board fault, as heating element insulation remains good when the programme fails, and unaffected when wires are removed from it.
Customer probably buying a new w/d but I wonder if you sent all three modules to QER? (Programme, Control & Display Modules)
jontyp.s. sad to see EMW have ceased trading recently.
- You must be logged in to reply to this topic.