1607 inner drum removal.

Home › Forums › Manufacturer/WP/Insurer Specific Forums › ISE Trade Support Forum › 1607 inner drum removal.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 20, 2015 at 8:48 pm #85891
    aqualectric
    Participant

    W288eco to be precise… the subject of my other squeaky bearing post. Squeaking stopped for a while …. and now it’s back!! 👿
    Machine in the workshop and I just cannot shift the inner drum – it just won’t come out despite much persuasion with ever increasing hammer sizes. No circlip around the shaft and seemingly no reason for it to not drift out.

    Am I missing something, or is there a special tool to remove the drum? I don’t remember the 1606 I did a while back needing anywhere near this level of force. Help please!

    Steve.

    August 22, 2015 at 10:57 am #429757
    kwatt
    Keymaster

    Re: 1607 inner drum removal.

    It’s just the same deal, same setup, bearings and everything.

    K.

    August 22, 2015 at 10:40 pm #429758
    aqualectric
    Participant

    Re: 1607 inner drum removal.

    Thanks Ken – 4lb lump hammer eventually did it. The seal was stuck fast to the drum shaft and needed overnight soaking with penetrating oil to finally shift it Friday morning. All done and back with customer!!

    Cheers,

    Steve.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.