aeg 64810 not completing cycle no error code

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › aeg 64810 not completing cycle no error code

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • May 12, 2011 at 7:44 pm #62769
    mikethemechanic
    Participant

    hello again,
    i have a aeg 64810 the fault i have found with it is every other wash it doesnt finish it freezes, i have not had any errors flashing up which is strange???
    i have it running on my test bay and yesterday i spent some time to watch it, i had it on a 95 wash cottons and with 80 minutes left on the clock it just sat there doing nothing then out of no where it burst into spin i have seen machines do this kind of thing on the rinse in the past but not these on the wash,
    i have checked the usual -low insulation, tested all components and examined the module the motor tests ok
    anyone think they can help me
    regards mike

    May 13, 2011 at 6:12 am #351251
    mikethemechanic
    Participant

    Re: aeg 64810 not completing cycle no error code

    oh just another quick note if i leave the wash on it goes back to the start but is full of water??
    cheers

    May 13, 2011 at 7:28 am #351252
    Martin
    Participant

    Re: aeg 64810 not completing cycle no error code

    Pump, sump hose or air chamber problems maybe?

    May 13, 2011 at 8:02 am #351253
    mikethemechanic
    Participant

    Re: aeg 64810 not completing cycle no error code

    Should do that fast spin on wash it’s like it’s trying to tumble but can’t turn slow I’ve checked the pump origanally and all is fine
    Please say someone has the answer???

    May 13, 2011 at 8:32 am #351254
    Criscold
    Participant

    Re: aeg 64810 not completing cycle no error code

    It sounds like motor tacho or wiring
    Have you tried diagnostic mode ?

    May 13, 2011 at 9:29 am #351255
    mikethemechanic
    Participant

    Re: aeg 64810 not completing cycle no error code

    Hi no tell me how I access it please

    May 13, 2011 at 12:45 pm #351256
    Martin
    Participant

    Re: aeg 64810 not completing cycle no error code

    mikethemechanic wrote:Hi no tell me how I access it please

    Email me your email address and I can send the info you need. 💡

    May 13, 2011 at 5:35 pm #351257
    mikethemechanic
    Participant

    Re: aeg 64810 not completing cycle no error code

    I sent you a private message with my email can u help can anyone help!!!

    May 14, 2011 at 8:00 am #351258
    Martin
    Participant

    Re: aeg 64810 not completing cycle no error code

    mikethemechanic wrote:I sent you a private message with my email can u help can anyone help!!!

    Didn’t get a PM from you Mike, just email me your address (via my email tag is best ‘cos I don’t always log onto UKW each time) and I can email….simples! 😀

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.