- This topic has 3 replies, 2 voices, and was last updated 3 years, 9 months ago by
.
Viewing 4 posts - 1 through 4 (of 4 total)
-
Posts
-
Been to look at this machine 3 days ago….I checked heater and circulating motor and any sights of water in base.., no faults were found ..I ran on a heat wash cycle while there and completed cycle…..Got a call this morning after the tenant managed another wash, on the third wash..It started to bleep 12 times very fast…any pointers please, not sure where to go next…cheers John
well a bit of guessing here
12 is hexidecimal C and the C fault codes are communication problams between the 2 boards
could it be a broken ribbon cable in the door going on and off ?
Dave
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.