AEG Dishwasher 911935627

[grooster]

Hi,
I went out to this dishwasher earlier in the week for the fault that it wasnt heating. It would go through the programme but just wouldn’t get hot.
I did the obvious and checked the heater and connections knowing that if this was the case it would more likely than not show a fault code or just carry on washing all day.
I came to the conclusion it must be the PCB, having had this loads of times on the Zanussi version.

Went out and fitted it yesterday, tried it on the 30 min programme and it heated fine.
I’ve just had a call from the customer saying shes had it on 2 more programmes and it hasnt heated since I left.
Has anybody come across this problem before? Could it be the NTC?
I’m scratching my head and I’ve got an upset customer.

Any help would really be appreciated.

Cheers

Nick

[Criscold]

Re: AEG Dishwasher 911935627

Just found this
Dynamic fill time
T.D. = T.S. x 3: This is the maximum time allowed for the entire fill phase within which the pressure switch
signal must stabilize on FULL.
• If the pressure switch signal does not stabilize on FULL within this period (T.S. x 3), the electronic
control system switches off the fill solenoid (and the heating element, if switched on), and then allows
the washing cycle to proceed until it is completed. In this situation, the alarm condition [F 0] is not
displayed to the user, but may be accessed by the Service Engineer using a specific procedure.

PM you email if you need the manual for this

Colin

[Author]

Posts